DY Realty Group, LLC has been retained on an exclusive basis to handle the leasing of 368 Stagg Street in East Williamsburg, Brooklyn. 

The site consists of a 15,000 sf 1-story building. The building has 3 drive-in doors, 14’ ceiling height, gas heat, & heavy power.

Centrally located in East Williamsburg, Brooklyn, a short distance to the Morgan Avenue L subway station & nearby bus lines, with direct access to all of New York City via the Brooklyn-Queens Expressway.

" /> 368 Stagg Street - 15,000 sf  - DY Realty Group, LLC

368 Stagg Street - 15,000 sf 

15,000 sf Industrial Warehouse For Lease

Property Details

DY Realty Group, LLC has been retained on an exclusive basis to handle the leasing of 368 Stagg Street in East Williamsburg, Brooklyn. 

The site consists of a 15,000 sf 1-story building. The building has 3 drive-in doors, 14’ ceiling height, gas heat, & heavy power.

Centrally located in East Williamsburg, Brooklyn, a short distance to the Morgan Avenue L subway station & nearby bus lines, with direct access to all of New York City via the Brooklyn-Queens Expressway.

Location

Address
368 Stagg St, East Williamsburg, Brooklyn, NY 11237
Block
3039
Lot
8
Subway
L L
Highways
Brooklyn Queens Expy Brooklyn Queens Expy

Sq Ft

Available Space
15,000 sf
Floors
15,000 sf
Plot
15,000 sf

Financials

Asking Lease
Call or Email $23.50 per sf

Construction

Use
Industrial-Warehouse
Bldg Description
1-Story
Stories
1
Ceiling
14'
Zone
M1-1
FAR
1
Drive-in
3

Image Gallery

Documents

Flyer
368 Stagg Street - 15,000 sf  Brochure

Location

L
L
Brooklyn Queens Expy
Brooklyn Queens Expy

Zoning

M1 districts range from the Garment District in Manhattan, with its multistory lofts, to parts of Red Hook and College Point with many one or two-story warehouses studded with loading bays. The M1 district is often a buffer between M2 or M3 districts and adjacent residential or commercial districts.

Light industries typically found in M1 areas include knitting mills, printing plants, woodworking shops, auto storage and repair shops, and wholesale service and storage facilities. In theory, nearly all industries uses can locate in M1 areas if they meet the more stringent M1 performance standards. Offices and most retail uses are also permitted. Certain community facilities, such as hospitals, are allowed in M1 districts only by special permit, but houses of worship are allowed as-of-right.

Floor area ratios in M1 districts range from 1.0 to 10.0 and building height and setbacks are controlled by sky exposure planes which may be penetrated by towers in certain districts. New industrial buildings are usually low-rise structures that fit within sky exposure planes. Except along district boundaries, no side yards are required. Rear yards at least 20 feet deep are usually required, except within 100 feet of a corner.

The M1-1 districts are usually near residential neighborhoods and frequently act as a low bulk buffer at the periphery of older industrial areas with heavier industrial uses and larger buildings. Typically, buildings in this zone cover approximately 75 percent of the lot and would have on-site open parking at the rear of the lot. M1-1 districts require off-street parking of one space per 2,000 sf, or per 3 employees, whichever is less. The maximum FAR is 1.0.

View All Our Listings
Exclusive

Send Us a Message

Standardized Operating Procedures